The JR2000 Series robot is one of
the world's most widely used platforms for automatic dispensing.
The simultaneous control over all axis provides for 3D linear
and arc interpolations that are required for complicated gasketing
processes. Janome has developed special application software
that simplifies programming of the robot for dispensing applications.
The JR2000 series robot can also be equipped with an UV spot
curing light source to cure material immediately for dispensing.
Janome provides turnkey systems
for screw fastening with either a Hios D/C electric clutch
type driver or the K/X Series Current Controlled Screwdriver
with 16 programmable channels. Janome has developed special
software for both the Hios and KX series screwdrivers to ensure
proper torque depth is achieved. Jamac, Inc. can provide either
blow-feed or pick and place configurations on the screw driving
system.
Jamac, Inc. offers turnkey soldering
solutions for both point and line soldering applications.
Our soldering software allows you to program 16 different
soldering conditions from easy to understand menus. With the
use of a geyan-feeder, solder balls and spattering have been
eliminated in the soldering process. Options are available
for wet sponge or blow-off cleaning. The JR2000 Series robot
is capable of being programmed for nearly any point or line
soldering application available.
Janome has incorporated offset algorithms
to accept X,Y,Z and R inputs to adjust work piece orientation
before a program is initiated. This allows the robot to ensure
accurate delivery of payloads and placement of tools. The
robot can also be equipped with CCD Cameras to inspect different
areas of circuit boards before dispensing, soldering, or driving
screws.
Jamac, Inc. offers a turnkey printed
circuit board depaneling system. Our JR2000 series Tab Router
is designed to cut printed circuit boards out of panels in
a tab-routed configuration with extreme accuracy. Options
include underside vacuum box for dust removal, ionized blow
off and automatic tool changer. Tab routing of circuit boards
is the only way to depanel without stressing your circuit
boards.
)
)
)
)
)
